TOHATSU MFS 8B Service Manual page 158

2. Run two cords from alternator through back of starter motor,
install starter motor and secure temporarily with bolts.
· Install starter motor with sticker side directing
toward you.
· Before installing bolts, coat the thread with
ThreeBond 1342.
· Check that two cords from alternator are not
caught between starter motor and crank case.
3. Tighten temporarily secured bolts to specified torque.
Starter motor bolt :
23.5 N · m (17 lb · ft) [2.4 kgf · m]
4. Install starter solenoid and PT solenoid (PT model) to
solenoid stay by using bolts and nuts.
Install PT solenoid in direction as shown.
5. Install solenoid stay on crank case.
Install lower two bolts to the case with bushing.
6. Secure both ground lead from starter solenoid and ground
cord together by using PT solenoid terminal (black). (PT
Model)
Arrange ground wires as shown.
5-54 4st 8/9.8 2016