5.
Install fuel pump
.
Apply engine oil to fuel pump cam surface.
6.
Attach timing belt to crankshaft pulley and cam shaft
pulley.
· For installation procedure, refer to "Installation
of pulley and timing belt" in Chapter 5.
· Ensure crankshaft rotates with no binding.
1.
Install starter motor bracket
torque. (E Model)
· Install starter motor bracket with "UP" mark
facing upward.
· Before installing starter motor bracket, coat
the bolts with ThreeBond 1342.
Starter Motor Bracket Installation Bolt :
23.5 N · m (17 lb · ft) [2.4 kgf · m]
2.
Install alternator
and exciter coil
Before alternator and exciter coil, coat the bolts
with ThreeBond 1342.
3.
Install pulser coil
on crank case.
Use starboard side mounting screw for securing
ground wire.
4st 8/9.8 2016
and tighten bolts to specified
.
5-51