2.
Use a press and suitable mandrel
bearing
onto propeller shaft housing.
Install ball bearing with manufacturer's marking
facing attachment side.
3.
Install reverse (C) gear ass'y onto propeller shaft housing.
1.
Remove pinion (B) gear nut, remove drive shaft ass'y
pinion (B) gear
, and draw out forward (A) gear.
• When removing drive shaft, be careful not
to give damage to shim on the bearing
outer race and not to lose the part. Shim is
reusable.
• Replace shim with new one of the same
thickness if any deformation or damage is
found on it.
1.
Check drive shaft for bend and wear. Replace if necessary.
4st 8/9.8 2016
to install new ball
and
6-15