TOHATSU MFS 8B Service Manual page 231

3. Remove bolt and washer
of the outboard motor, and then upper cylinder pin
Upper cylinder pin can be removed easily when
tilt rod is retracted a little by performing tilt down
operation.
4. Remove cap, and loosen nylon nut of port side bracket and
clamp screw.
5. Remove bolt and washer
to remove lower cylinder pin.
· Remove PT assembly taking care not to drop
it.
· Pry port side clamp with means such as
handle of plastic hammer to make gap that
makes removal of PT assembly easy.
4st 8/9.8 2016
located on the starboard side
.
, and use a proper punch
7-37