TOHATSU MFS 8B Service Manual page 207

5. Install cable of which inner wire is stretched when
acceleration grip is set to full close position.
6. Then, install another cable
stretched when acceleration grip is set to full open position.
7. Adjust position of lock nuts
grip can reach full open and full close positions.
Adjust cable tension so that it moves approximately
1mm when pushed lightly with a finger.
1. Install co-pilot plate.
2. Move co-pilot handle to left to slide it to tightening position.
3. Tighten nylon nut until steering load becomes heavy.
Tighten nylon nut
lb · ft) [0.6 kgf · m] and check steering load.
4. Move co-pilot handle to the right to slide it to release
position, and check that steering can be made lightly. If not,
repeat steps 2. to 4. to finely adjust.
To prevent nylon nut from falling, tighten stud bolt
until more than 13–14 mm
top plate.
4st 8/9.8 2016
(of which inner wire is
of throttle cable so that throttle
to approximately 6 N · m (4
can be seen above
7-13