INFORMATION FOR REPLACING THE
4. Screw the new filter G onto the pump Q (tightening
torque 20 Nm).
5. Connect the hose E to the filter G and fasten with the
clamp D.
6.8 Oil vapour separator replacement
6.8.1 Disassembly
Important
•
Before proceeding with operation, read
1. Release the clamp AA and remove the pipe D.
2. Release the clamps F.
3. Remove the clamp P cutting it in the point indicated
and remove the separator body C removing it from
the hose AG and G.
4. Release the clamp F.
5. Remove the pipes G and AG.
6. Undo the screws B.
7. Release the clamp S from the sleeve K.
8. Pull the flange H out of the manifold K and remove
the relevant gasket, being careful not to bend the pipe
E.
6.8.2 Assembly
Warning
•
Always carefully inspect the condition of the tubes,
and replace them if there is any doubt regarding their
integrity.
•
Always replace the gasket M after each assembly.
1. Check that the contact surface L is free from
impurities.
FUNCTIONAL UNITS
Par.
3.3.2.
Fig 6.63
Fig 6.64
Fig 6.65
6
79
EN