Kohler KDI 2504TM Workshop Manual page 69

INFORMATION FOR REPLACING THE
6.1.9 Assembly Rocker arm cover
Important
•
The gasket AM between the rocker arm
cover and the cylinder head must always be
replaced every time it is disassembled.
1. Position the two guide pins
mounting the rocker arm cover.
2. Position the gasket AM on the head AL
respecting the fastening screw holes L.
3. Attach the rocker arm cover C on the head
AL with the screw L adhering to the
tightening sequence shown in Fig. 6.26.
4. Connect pipe H and tighten the clamp G.
5. Connect tube H to turbine AS and tighten
clamp G.
6. Fasten flange AT by means of capscrews
AR to manifold AU, inserting gasket AV.
Important
•
Always replace the gaskets AK (ST_36) -
AV after each disassembly.
FUNCTIONAL UNITS
Fig 6.25
ST_17 before
Fig 6.26
Fig 6.28
6
69
EN