Kohler KDI 2504TM Workshop Manual page 155

INFORMATION ABOUT OPTIONAL
11.4.2 Assembly
Important
•
Always replace the gasket J after each assembly.
•
Lubricate the gear H with oil.
•
It is mandatory to replace the screws N or apply a few
beads of Loctite 2701.
1. Insert the gear H in the flange F in the direction of the
arrow R inserting the shoulder ring G.
2. Insert the shoulder ring E on the flange F and clamp
the gear H using the retainer ring D.
3. Position the flange F on the crankcase K inserting the
gasket J, and inserting the gear H up to the stop on
the bearing L (Fig. 11.31).
4. Secure the flange F using the screws N (tightening
torque at 25 Nm).
Important
•
Always replace the gaskets P and Q at each assembly.
5. Insert the centring ring C in the flange F up to the stop.
6. Insert the pump B on the flange F engaging the gear H.
7. Secure the pump B using the screws A on the flange F
(tightening torque at 25 Nm).
COMPONENTS
Fig 11.17
Fig 11.18
Fig 11.19
Fig 11.20
11
155
EN