Coolant Circuit Assembly - Kohler KDI 2504TM Workshop Manual

- Q and R;
- Q and S;
- Q and H.
Fasten the fuel outlet pipe Q with the fittings
R on the turbo-compressor H and on the
crankcase S (tightening torque of 15 Nm).
9. Follow operations 4 and 5 of Par. 6.1.9.

9.14 Coolant circuit assembly

9.14.1 Thermostatic valve
Important
•
Always replace the gasket A after each assembly.
1. Check the condition of the seal gasket A and fit it on the
thermostatic valve B.
2. Position the thermostatic valve B in the seat on the head
C (detail D).
3. Secure the cover E with the screws F on the head C
(tightening torque of 10 Nm).
9.14.2 Coolant pump
Important
•
Always replace the gasket L every time it is assembled.
1. Fit the pump G with the screws H interposing the gasket
L (tightening torque of 25 Nm).
ASSEMBLY INFORMATION
Fig 9.84
Fig 9.85
9
137
EN