11
washers H, the screws A and the cable B.
2. Secure the flange H with the screws A (tightening torque
at 22 Nm).
3. Secure the earth cable B with the nut J and the relevant
washer on the heater E.
11.3 Idler gear (for 3rd / 4th PTO)
Important
•
Before proceeding with operation, read
11.3.1 Disassembly
1. Undo the screw A and remove the gear unit B.
2. Remove the retainer ring C from the seat of the pin D.
3. Remove the shoulder washer E, the gear B, the shoulder ring
F and the bushing G from the pin D.
11.3.2 Assembly
1. Fit into the pin D :
- The shoulder ring F (of least thickness)
- The gear B
- The shoulder ring E
- The retainer ring C.
2. Insert the bushing G on the crankcase L.
EN
152
INFORMATION ABOUT OPTIONAL
COMPONENTS
Par.
3.3.2.
Fig 11.8
Fig 11.9
Fig 11.10