6
6.6 Oil cooler unit and oil filter replacement
6.6.1 Oil Cooler unit disassembly
Important
•
Before proceeding with operation, read
•
Perform the operations described in
5.2.
•
Oil Cooler unit E is not repairable.
1. Release the clamps A.
2. Remove the pipes B out of the Oil Cooler unit E.
Warning
•
Electric/pneumatic screwdrivers are forbidden.
•
Use a suitable container to recover any residue oil.
3. Unscrew cartridge holder cover H by performing three
complete turns and wait 1 minute.
NOTE : this operation allows to oil contained in the support E to
flow into the oil sump in the correct way.
4. Unscrew cartridge holder cover H and check that the oil
in the lub. oil filter support E has flowed towards the oil
sump.
5. Undo the screws C and D and remove the Oil Cooler
unit E.
6. Remove the gaskets F and G from the Oil Cooler unit E.
EN
76
INFORMATION FOR REPLACING THE
FUNCTIONAL UNITS
Par 5.1
Par.
3.3.2.
and
Par
Fig 6.67
Fig 6.68
Fig 6.69