Kohler KDI 2504TM Workshop Manual page 115

9.3.3 Camshaft
1. Check that the bushing Q is correctly fitted.
2. Lubricate the pins L, the cams M of the camshaft N, all
the housing P (Par. 8.2.4 and Par.
bushing Q with oil.
3. Insert the camshaft N all the way into its housing P.
4. Fit the lock ring R on to the crankcase E to hold the
position of the camshaft N.
5. Manually rotate the camshaft N ensuring that it is free.
9.3.4 Vent compartment closure lid
1. With the screws CF tighten the cover CG and the
gasket CH (tightening torque to 10 Nm).
9.3.5 Crankshaft
Important
•
Carry out the checks described in
8.4.2.
1. Check that the crankshaft half-bearings are mounted
correctly on the upper crankcase E.
2. Lubricate the main journal and crankpin J, with oil.
3. Insert the crankshaft W into its seat on the upper
crankcase E.
4. Insert the 2 shoulder half-rings K, between the
crankshaft W and the upper crankcase E (AB detail).
9.3.6 Lower crankcase
Important
•
Before proceeding to the assembly of the piston and
connecting rod, carry out the checks described in
8.5.1.
ASSEMBLY INFORMATION
8.2.6) and the
Par. 8.4.1 and Par.
Fig 9.3
Fig 9.4
Fig 9.5
Fig 9.6
Par.
Fig 9.7
9
115
EN