Kohler KDI 2504TM Workshop Manual page 131

5. Insert tool ST_51 on the injectors junctions Z
(detail X1).
6. Tighten the screw P (tightening torque to 20 Nm)
9.8.2 Fuel injector ricicle pipe
1. Position the tube N on the injectors Z, and
tighten screws M (coppia di serraggio a 14
Nm) and insert the gasket T.
9.8.3 Rocker arm cover
Important
•
Always replace the gaskets AK after each
disassembly (ST_36).
1. Position tool
ST_17
correspondence with the two fastening holes
5 and 6 (Fig. 9.67).
2. Position the gasket AM on the head AL using
tool ST_17 as a guide.
3. Fit the rocker arm cap C on the head AL via
the screws L observing the clamping
sequence illustrated in Fig. 9.67.
4. With vaseline lubricate the gaskets AK.
ASSEMBLY INFORMATION
onto the head in
Fig 9.63
Fig 9.64
Fig 9.65
Fig. 9.67
9
131
EN