Kohler KDI 2504TM Workshop Manual page 77

INFORMATION FOR REPLACING THE
6.6.2 Oil filter cartridge replacement
1. Remove gaskets L, M and N from element holder cover
H.
2. Remove cartridge P from element holder cover H.
1. Lubricate and insert gaskets L, M and N in the L1, M1
and N1 seats of element holder cover H.
2. Insert element P into element holder cover H.
6.6.3 Oil Cooler unit assembly
Important
•
In the event of assembly of union U on crankcase S,
manual tightening torque with Loctite 2701 on the
thread).
Fig 6.72
1. Check that the surface Q on the support E and on the
crankcase S are free from impurities.
2. Lubricate and insert the gasket T on the fitting U.
3. Lubricate and insert the gaskets on the support E :
F in seat F1;
G in seat G1.
4. Fit the support R with the screws C and D (tightening
torque at 10 Nm).
FUNCTIONAL UNITS
Fig 6.70
Fig 6.71
Fig 6.73
6
77
EN