9 ASSEMBLY INFORMATION
9.1 Information on engine configuration
•
In this chapter, the engine is represented as "BASE CONFIGURATION" (refer to
1.4).
•
For the assembly of components not described in this chapter refer to
•
The following are the components described in
11.1
Oil dipstick in cylinder head
11.2
Heater (replacement)
11.3
Idler gear (for 3
/ 4
rd
11.4
3
PTO (replacement)
rd
11.5
4
th
PTO (replacement)
11.6
3
+ 4
PTO (configurations)
rd
th
11.7
Air filter (cartridge replacement)
11.8
Remote oil filter (disassembly and assembly)
11.9
Poly-V alternator belt (replacement and adjustment)
11.10
Tightening pulley and alternator for Poly-V belt
9.2 Assembly recommendations
•
The information is laid out in sequence, the intervention methods have been selected, tested and
approved by the manufacturer's technicians.
•
This chapter describes the installation procedures for the assemblies and/ or individual components
which have already been checked, overhauled or possibly replaced with original spare parts.
•
Where necessary, reference to special tools during assembly operations is indicated and identified
in
Tab.
13.1, hereinafter in Tab. 9.1 an example of a special tool (ST_05).
Tab. 9.1
"ST" Code
ST_05
Important
•
Before proceeding with operations, read
•
To easily locate specific topics, the reader should refer to the analytical index or chapter index.
•
The operator must check that:
ASSEMBLY INFORMATION
PTO)
th
SPECIAL TOOLS
Picture /draw
Par.
Chap.
11.
DESCRIPTION
Six nicks Key SN 8
3.3.2.
9
Par 1.3
-
Par.
Chap.
11.
PART NUMBER
ED0014603650-S
113
EN