Fuel System Assembly - Kohler KDI 2504TM Workshop Manual

9

9.8 Fuel system assembly

Important
•
Replace the high pressure pipes after two
disassemblies.
•
Remove the protective caps from all the
components of the fuel circuit just before
assembly
•
When repaired, RSN-A injectors must be
certified by a Stanadyne centre to check their
correct operation - check the type of engine
mounted injectors on the spare parts list
(RSN-A is specified in the description).
9.8.1 Injector
1. Lubricate the gaskets U, T, S, and fit them on
the injector Z.
2. Fit the injector Z in the sleeve V.
3. Assemble parts P, Q, R.
4. Fit the parts so assembled on the injector Z.
EN 130
ASSEMBLY INFORMATION
(Par. 2.9.7).
Fig 9.59
Fig 9.60
Fig 9.61
Fig 9.62