Kohler KDI 2504TM Workshop Manual page 63

INFORMATION FOR REPLACING THE
6.1.2 Rocker arms cover disassembly
1. Undo the screws AR.
2. Loosen clamp G and disconnect hose H
3. Undo the screws L and remove the rocker
arm cap C.
6.1.3 Fuel return pipes disassembly
1. Undo the screws M and remove hose N.
6.1.4 Injectors disassembly
1. Undo the screw P and remove washer Q
and bracket R.
2. Remove the injector Z.
NOTE : Should you be unable to remove the
injector (acting only on point BC), use an open-
ended spanner (11 mm), by applying small rotations
to unblock the component.
3. Seal all injection component unions as
illustrated in Par.
4. Ensure that gasket S has remained in the
correct position (Fig. 6.7). Otherwise,
recover the gasket from inside the
electronic injector V manifold.
NOTE : If the washer S is not found on the injector
Z, recover it from inside the sleeve V.
FUNCTIONAL UNITS
2.9.7.
Fig 6.4
Fig 6.5
Fig 6.6
Fig 6.7
6
63
EN