Kohler KDI 2504TM Workshop Manual page 161

INFORMATION ABOUT OPTIONAL
with a tool the fittings K, H (Fig. 11.37) and L
(Fig. 11.38) in order to prevent their lose
together with the nuts A, with the consequent of
oil leakage.
2. Undo the nuts A and remove the hoses B and C.
3. Release the clamps D and remove the hoses E and F
from Oil Cooler G.
4. Unscrew and remove the fitting H with its copper gasket
from the oil filter head J.
5. Unscrew and remove:
- the fitting K with the copper gasket;
- Oil Cooler G and the relative gaskets;
- the oil filter head J.
6. Unscrew the fittings L and remove the copper gaskets
from the support M.
7. Unscrew the cartridge N with gasket from the support M.
11.9.2 Assembly
Important
•
Always replace the gaskets V after each assembly.
•
Always replace the gaskets P, Q, and U at each
assembly.
•
Lubricate the gaskets P, Q with oil before assembling
them.
1. Clamp unions L on support M inserting gasket V
(tightening torque at 40 Nm).
2. Lubricate gasket W and clamp cartridge N on support M
(tightening torque at 20 Nm).
3. Insert the gasket P on the seat of the fitting K.
4. Insert flange head J on the union K and the gasket Q in
the seat of head J.
5. Insert the Oil Cooler G on the union K and the gasket R
in the seat of Oil Cooler G.
6. Onto crankcase S apply Oil Cooler G and flange J by
means of union K (tightening torque at 25 Nm + Loctite
COMPONENTS
Fig 11.37
Fig 11.38
Fig 11.39
11
161
EN