Kohler KDI 2504TM Workshop Manual page 101

INFORMATION ABOUT OVERHAULING
PISTON Ø CILINDER (± 0.007 mm)
STD 88.010
(1)
+0.20 88.210
Fig 8.2
N.B.: if removing the Z2 hole closing cap, the new cap must comply with the MAX measurement of
1.5 mm from the surface G1
Fig 8.2a
8.2.3 Block Surface Flatness
Use a dial gauge to check if the cylinder head surface A1
is level.
The MAX value of allowable irregularity of surface A1 is:
•
0.10 mm on the entire area;
•
0.03 mm on an area of 100x100 mm.
Ø PISTON (± 0.007 mm)
87.950
88.150
8
CLEARANCE VALUE (mm)
0.046 - 0.074
101
Fig
8.2
b
EN