6
3. Undo the screw P (clockwise) and remove the pulley Q.
6.3.2 Assembly
1. Check that the pin U is mounted properly on the
camshaft V.
2. Insert the pulley Q on camshaft V respecting the
reference of the pin U.
3. Apply Molyslip grease on the screw thread P.
4. Fit the pulley Q with the screw P (tightening torque 360
Nm) and remove the tool ST_34.
6.4 Oil pump replacement
Important
•
Before proceeding with operations, read
•
The oil pump is not repairable.
6.4.1 Coolant pump disassembly
1. Perform the operations described in
6.4.2 Engine pulley disassembly
1. Perform the operations described in
6.4.3 Timing system crankcase disassembly
Important
•
Perform the operations described in
1. Make sure that the reference pin A is facing
upwards.
2. Undo the screws B and remove the timing system
crankcase C.
EN
72
INFORMATION FOR REPLACING THE
FUNCTIONAL UNITS
Par
Par
Par.
Fig 6.36
Fig 6.37
Par.
3.3.2.
6.2.1.
6.3.1.
5.2.
Fig 6.38