Crankshaft Pulley Disassembly - Kohler KDI 2504TM Workshop Manual

7
7.5.2 Thermostatic valve
1. Undo the screws D and remove the thermostatic valve
cover E.
2. Remove the thermostatic valve F and its gasket.
Important
•
Always replace the gasket G every time it is
disassembled.
3. Check that the air bleeding hole is not clogged or
blocked
7.5.3 Coolant recirculation components disassembly
Important
•
The pump B is not reparaible
1. Undo the screws A and remove the water pump unit B
with its gasket C.

7.6 Crankshaft pulley disassembly

NOTE: Perform the operations described in
and 3.
1. Undo the screw A (clockwise - as seen from the timing
system side - Ref. A
EN 84
INFORMATION FOR DISASSEMBLY
(Par. 2.11.3).
Par. 1.3) and remove the pulley B.
Fig 7.10
Fig 7.11
Par. 6.1.5 points 2
Fig 7.12