6
Oil filter cartridge replacement
•
•
6.2 Oil filter cartridge replacement
• Electric/pneumatic screwdrivers are forbidden.
1. Unscrew cartridge holder cover A by performing three
complete turns and wait 1 minute.
NOTE:
This operation allows to oil contained in
the support F to flow into the oil sump in
the correct way.
2. Unscrew cartridge holder cover A and check that the oil
in the lub. oil filter support F has flowed towards the oil
sump.
3. Remove the cap A as well as the oil cartridge B from the
oil filter support.
4. Remove and replace the oil cartridge B with a new one.
Remove and replace the gaskets C, D and E with new
ones.
5. Fit and tighten the cover A on the oil filter support F,
tightening it with a torque wrench (tightening torque of 25
Nm).
EN
36
INFORMATION ABOUT REPLACEMENTS
In case of low use replace it 12 months.
•
For disposal of oil filter cartridge and fuel filter refer to
Par. 6.6 DISPOSAL and SCRAPPING.
Important
Warning
(Par.
6.2) and fuel filter replacement
A
6.4
B
6.5
F
6.6
(Par.
6.4)
A
F
D
C
A
B
E