Table of Contents
Advertisement
INFORMATION ABOUT REPLACEMENTS
6 INFORMATION ABOUT REPLACEMENTS
6.1 Engine oil replacement
Danger
• Disconnect the negative wire (-) from the battery to avroid
accidental engine stating.
Important
• Before proceeding with operation, read
• Place engine on level sur face to ensure accurate measurement of
oil level.
•
Before proceeding, perform the operation described in
Point 1.
NOTE : Perform this operation with warm engine, to get a better fluidity of
the oil and get a full discharge of oil and impurities contained in it.
1. Loosen the oil filler cap A (Fig. 6.1) .
2. Remove the oil dipstick B .
3. Remove the oil drain plug D and the gasket E (the oil drain plug is
on both sides of the oil sump).
4. Drain oil in an appropriate container.
(For the exhausted oil disposal, refer to
SCRAPPING
).
5. Replace gasket E .
6. Tighten the drain oil plug D (tightening torque at 50 Nm ).
7. Perform the operation described in
8. Add the type and amount of oil recommended (
2.2
).
Important
• Do not use the engine with the oil level below the MIN .
• Do not exceed the MAX level on the dipstick.
9. Fit and remove the oil dipstick B to check the level.
Pour in fluid until reaching the MAX level mark.
10. Upon completion, reinstall the oil dipstick B completely.
11. Tighten the cap A .
Par. 3.2.2
Par. 6.2
Par. 6.5 DISPOSAL and
Par. 6.2
- point 2 to 5.
Tab. 2.1
and
-
Fig. 6.1
Fig. 6.2
Tab.
Fig. 6.3
6
49
EN
Advertisement
Table of Contents
