Table of Contents
Advertisement
2.11 Quick Start Guide
2.11.1 Program Ready Screen
At initial power up, the controller displays the
P
R
ROGRAM
To run the displayed program, select F1 for
R
. Program timer begins and the program
UN
runs as specified.
• Select F1 to S
point of the program running mode.
• Select F1 again to R
and go back to the P
To configure the program settings, select F3 for
M
. Use the arrows to the right of the
ENU
display to scroll through the programs (1-6).
Press F3, or S
configure.
• Optionally scroll through the P
C
ONFIGURATION
using the arrow keys to select which
program setting to configure. The
following list displays all of the variable
sub-settings within each program
setting.
2.11.2 Program Configuration
Cycle: Set the sampling parameters here.
Prepurge: Enter the number of seconds (0-99)
for the system to purge the intake lines prior to
sampling. Then press F3 to accept.
screen:
EADY
the program at any
TOP
to select the program to
EL
(P
GM
Section 2 Installation
the program
ESET
R
GM
EADY
C
) menu
ONFIG
screen.
ROGRAM
2-25
Advertisement
Table of Contents
