Setting The Time Each Day When The 8010-Sie-Gps Ii Will Synchronize To The Gps Time; Entering The Time Zone Offset - evertz 8010-SIE Instruction Manual

3.9.4. Setting the Time Each Day when the 8010-SIE-GPS II will Synchronize to the GPS time.

The 8010-SIE-GPS II can also be set to resynchronize once per day at a user specified time, so that
the optimal time accuracy is continuously maintained, at the same time minimizing the potential for
code disturbances during resynchronization.
The GPS@ register contains the time each day when the internal UTC clock will be synchronized to the
GPS receiver time. Normally this time should be set to occur during a time of the day least likely to
cause interruptions if there is a minor skip in the time (usually between midnight and 6:00 am). The
factory default setting for the GPS@ register is midnight. To set another value into the GPS@ register,
use the following procedure.
Press the SHIFT + DISPLAY buttons one or more times until the GPS@ prompt is shown at the left of
the display. The ENTER and CLEAR keys are used in conjunction with the numeric keys to set the
generator time.
Press the ENTER key to recall the last time that you entered into the GPS@ register. The display
prompt at the left of the display will blink while data entry mode is active, and the dual functioned keys
are now changed to their numeric values. If you want to re-enter this time press the ENTER key to
complete the data entry into the GPS@ register.
Pressing any numeric key will clear the previous value and place the new value into the numeric
display, starting at the right. Unentered digits are assumed to be zero, hence leading zero digits are
not required. When the required number of digits are entered, then press the ENTER key to complete
the data entry into the generator time.
Attempts to enter too many digits, or make illegal entries, i.e. 65 minutes, will result in the display
returning to the last valid time entry made. Re-enter the correct value and press the ENTER key.
Pressing the CLEAR key will cancel the data entry mode without changing any data.
The numeric keys return to their normal display functions when the data entry has been completed by
pressing ENTER or canceled by pressing the CLEAR key. The display prompt will return to its steady
On state when data entry mode has been completed.
Numeric entry mode must be terminated (GPS@ will be On steady) before any of
the front panel keys will resume normal operation.

3.9.5. Entering the Time Zone Offset

The 8010-SIE-GPS II is capable of displaying time/date information in either the Universal Coordinated
Time (UTC) or the local time that has been adjusted with the appropriate time zone offset from UTC. In
local time mode, the generator encodes the time adjusted for the local time zone offset from UTC. In
local time mode, the time is also adjusted for Daylight saving time when the DST TIME menu setting is
set to On. In UTC mode, the generator encodes the UTC time and date received from the receiver
antenna.
To enter the time zone offset press the DISPLAY buttons one or more times until the TIME ZONE
prompt is shown at the left of the display. The ENTER and CLEAR keys are used in conjunction with
the arrow keys to set the time zone.
OPERATION
Model 8010-SIE Digital Source ID Encoder Manual
Revision 2.2
Page 3-30