Creating A New Settings Profile - Agilent Technologies WireScope 350 User Manual

@‘ƒr…‡ÃH‚qrÃs‚…Ã8‚ƒƒr…ÃUr†‡vt
UurÃ@‘ƒr…‡Ã6ˆ‡‚‡r†‡ÃTr‡ˆƒ

Creating a New Settings Profile

6−6
Password Screen, where you can choose to password protect your
profile.
3 If you choose to password protect your profile, you will be prompted
to enter the password. Once you are satisfied with your password
selection, press OK to return to the Autotest Settings screen, where
the locks will be shown. If it is password protected, you will now be
prompted to enter the password in order to modify this profile.
A new profile may be created either directly on the WireScope 350 or on
a PC using ScopeData Pro and subsequently downloaded into the
WireScope 350. To create a settings profile directly on the WireScope
350:
1 You must configure all the Autotest Settings to the desired settings
prior to creating a new profile. Profiles created on the WireScope 350
use the existing settings for all the parameters. See the remainder of
this section to configure the other settings.