8r
vsvtÃAvir
Ã8hiyvt
8hyvi
hvtÃurÃU rr
Calibrating the Tester
Calibrating for Double-Ended Testing
.
4−4
Before you begin a test, the WireScope and DualRemote pair must be
calibrated. Calibration allows the WireScope to compensate for slight
anomalies in its measurement hardware or that of the companion
DualRemote unit.
Method A
This method is commonly called Method A or the 2-jumper method and
is usually recommended for singlemode fiber.
1RWH
VrÃurÃhrÃphyvi
hvÃruqÃurur
ÃÃh
rÃrvtÃÃsvir
Ã
ÃwÃrÃsvir
1 Insert a Fiber SmartProbe
+
SmartProbe
multimode or singlemode.
1RWH
TvtyrqrÃAvir
ÃTh
Q
irÃrÃhÃyhr
ÃyvtuÃ
prÃuhÃ
rv
rÃh
vtÃÃirs
rÃ
rÃ7rs
rÃphyvi
hvtÃ
ÃrvtÃvuÃvtyrqrÃsvir
Ã
irÃhyhÃprpÃurÃ
irÃ
ÃÃurÃXv
rTprÃhqÃ9hySrrÃvsÃrqÃhqÃhvÃsvrÃvrÃs
ÃÃ
hpp
hrÃ
rhqvt
2 Connect duplex test jumpers to the two Fiber SmartProbes.
3 Connect the test jumpers to each other, using two couplers. Connect
the WireScope transmitter to the DualRemote detector, and vice
versa.
4 Turn on the WireScope and DualRemote.
The WireScope detects a Fiber SmartProbe
following window:
+
in the WireScope, and a Fiber
in the DualRemote. They should both be either
+
, and displays the