Indicators - Agilent Technologies WireScope 350 User Manual

Br‡‡vtÃT‡h…‡rq
UurÃ9ˆhySr€‚‡rÃ"$

Indicators

1−18
Scroll: The Scroll button scrolls through the diagnostic indications.
(See Diagnostics, on page 1-19.)
Pair Status Indicators
The pair status indicators turn green or red at the end of a test to show
the status of each pair. A red indicator means the associated pair failed
the current test.
Warning Indicators
The warning indicators denote conditions that might prevent or impair
testing.
Hub/NIC Detected: The Hub/NIC Detected indicator means the
DualRemote 350 is connected to a hub/Switch port or NIC port, instead
of to a port connected to the WireScope 350. [This function is not yet
supported.]
Voltage Warning: The voltage warning indicator means the
DualRemote 350 is connected to a line which has a potentially damaging
voltage present. This condition usually occurs when attempting to test a
line that is connected to a telephone switch.
&DXWLRQ
DsÃ’‚ˆÃ†rrÇuv†Ãvqvph‡‚…Ãv€€rqvh‡ry’Ãqv†p‚rp‡Ã‡urÃ9ˆhySr€‚‡rÃs…‚€Ã‡urÃyvrÃ
Ahvyˆ…rÇ‚Ãqv†p‚rp‡Ã‡urÃyvrÃphÃƒr…€hr‡y’Ãqh€htrÇurÃ9ˆhySr€‚‡rÃ"$
Calibration Required: The Calibration Required indicator means the
DualRemote 350 is not calibrated to the WireScope 350. The autotest will
not execute until the calibration is performed.
Battery: The battery indicator shows the current state of the
DualRemote 350 battery charge.
When an external charger is supplying power to the DualRemote:
• The Battery indicator is steady green when the battery is charging.
• The Battery indicator flashes rapidly green when the battery is
fully charged. It may flash slowly if it is cooling between charging
cycles.
When no external charger is connected to the DualRemote:
• The Battery indicator is dark when the battery is operating
normally.
• The Battery indicator is red when the battery charge is low.
&DXWLRQ
V†ry’Çurà !WÃpuh…tr…hqhƒ‡r…ƈƒƒyvrqÐv‡uÃ’‚ˆ…ÃXv…rTp‚ƒrÃhqÃ9ˆhySr€‚‡rÃ
V†vtÃh’‡ur…Ãpuh…tr…hqhƒ‡r…ÃphÃqh€htrÃ’‚ˆ…ÃXv…rTp‚ƒrÃr„ˆvƒ€r‡ÃhqÉ‚vqÃ
’‚ˆ…Ðh……h‡’