Choosing the Connector Type
Connectors from different manufacturers have different transmission
characteristics. The WireScope 350 compensates for those differences, if
you tell it what connectors are used on the job.
1 On the Autotest Setup screen, press the connector icon, then press
1RWH
UurÃp
yyÃih
ÃÃurÃ
vtuÃsÃurÃp
rrÃuÃurÃyphvÃsÃurÃqhhÃuÃhqÃvÃÃ
hÃspvhyÃp
yyÃih
ÃUÃp
yyÃrÃurÃp
yyÃiÃhÃurÃyr
Ã
vtuÃsÃurÃ
Xv
rTpr
2 Press the manufacturer of the connector, then Next. A list of that
3 Press the name of the connector, then press OK. The Autotest Setup
Choosing the Cable Pairing Convention
To identify the correct pair in the test results, the WireScope must be
told what cable pairing convention is used. For example, if the 3,6 pair
fails a test, it would be "Pair 2" if using T568A pairing, but it would be
"Pair 3" if using T568B pairing.
Edit. The Connector Setup screen displays.
manufacturer's connectors displays.
screen displays, with the selected connector type next to the
connector icon. If the connector type is not in the connector
database, see Adding a new connector type, on page 3-16.
@r
ÃHqrÃs
Ã8r
ÃUrvt
UurÃ@r
Ã6rÃTr
6−13