8r
vsvtÃ8r
Ã8hiyvt
SvtÃhÃ6r
Running an Autotest
3−20
To run an autotest:
1 If this is the first test of the day or after a long break, calibrate the
tester. See Calibrating the Tester, on page 3-2.
2 Connect the WireScope 350 and Dual Remote 350 to the ends of the
circuit needing certification.
3 On the WireScope Main Menu, press the button identifying the
selected test. The test executes.
1RWH
DsÃÃpuhtrÃr
rÃhqrÃÃurÃqrshyÃrvtÃhqh
qÃ
Ã
svyrÃurÃHhvÃHrÃ
uÃiÃs
Ã8hrt
Ã$@ÃhqÃ8hrt
Ã%ÃrÃDsÃurÃQ
svyrÃuhÃirrÃpuhtrqÃ
urÃHhvÃHrÃuÃyÃrÃrÃiÃvqvphvtÃurÃrÃrÃ
svyr
4 If the autotest passes, the screen will look like this:
5 To save the test results, see Chapter 5 Saving Test Results.