Table of Contents
Advertisement
V†vtÃXv…rTp‚ƒr
UurÃT’†‡r€ÃTr‡‡vt†ÃHrˆ
2−10
Operators: The Operator Setup screen has controls for entering the
names and locations of the technicians using the WireScope and
DualRemote.
Calibrate Touchscreen: This screen guides you through a calibration
of the touchscreen. Make sure you have a stylus available before
entering this function.
Serial Baud Rate: The Serial Baud Rate Setup screen selects one of
three data transfer rates for communication with a PC.
Restore Default Settings: This screen lets you clear the operator list
and custom limits. It also changes all settings back to a known state,
which is it's main function.
Calibration Information: This screen displays the serial numbers of
the WireScope 350 and DualRemote 350, the date they were calibrated at
the factory, and the date they were last calibrated in the field.
Autoprint: This screen turns autoprinting on and off. This should be
turned on if you wish to print labels on an attached Brady TLS2200
printer after each test record is saved.
Demo Mode: This screen turns Demo mode on and off. Demo mode is
useful when learning to use the WireScope and does not reflect the
actual cable/run attached to the WireScope.
Advertisement
Table of Contents
