Agilent Technologies WireScope 350 User Manual page 126

cable is automatically selected. Press the Edit Settings button to
change any settings.
1RWH UurÃXv…rTp‚ƒrÃ"$Ãq‚r†Ã‚‡Ã†ƒrpvs’Ãh’Ár‡‚…xvtƇhqh…q†Ã‡uh‡Ã…ˆÃ‚ÃUvh‘Ã
phiyrÃ6’Ãh‡‡r€ƒ‡Ã‡‚Ã…ˆÃhÃ8r…‡vs’ÃIr‡‚…x†Ã‡r†‡Ã‚ÃhÃUvh‘ÃphiyrÐvyyÇ…vttr…ÃhÃr……‚…Ã
€r††htrƇh‡vtÇuh‡Ã‚rÂsÇurÁr‡‚…x†Ã†ryrp‡rqÃh…rÃp‚svtˆ…rqÇ‚Ã…ˆÃ‚Ã‡uv†Ã‡’ƒrÂsÃ
phiyr
2 Press the Start Test button from the Autotest Setup screen to
perform the Twinax Autotest
Results
The Twinax Autotest evaluates length and cable integrity. Twinax cable
integrity includes the detection of a properly connected shield. These
results are shown in both the diagram at the top of the screen and the
table at the bottom. Delay and NVP information are also shown. Pressing
the Details button shows more information about the test.
@‘ƒr…‡ÃH‚qrÃs‚…Ã8‚ƒƒr…ÃUr†‡vt
SˆvtÃ8P6YÃhqÃUXDI6YÃ6ˆ‡‚‡r†‡†
6−27