Removing And Replacing The System Battery - HPE ProLiant DL20 Gen10 User Manual

Removing and replacing the system battery

Removing and replacing the system battery
Prerequisites Prerequisites
Before you perform this procedure make sure that you have a flat-bladed, nonconductive tool.
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Remove the access panel .
7. Locate the battery.
8. Remove the system battery:
a. Use a small flat-bladed, nonconductive tool to press the battery latch (callout 1).
b. Remove the system battery from the socket (callout 2).
9. Install the system battery:
a. With the side of the battery showing the "+" sign facing up, insert the battery into the socket (callout 1).
b. Press the system battery down until it clicks into place (callout 2).
Removing and replacing the system battery 234