Drive Cage Options; Installing The 8-Bay Sff Drive Cage - HPE ProLiant DL180 Gen10 User Manual

5. If removed, install the front bezel.
6. Determine the status of the drive from the drive LED definitions.
The installation is complete.
To configure arrays, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard Enterprise
website.

Drive cage options

The server supports the following drive cage options:
• 8-bay SFF drive cage
Rear 2-bay SFF drive cage
•
The 8 LFF chassis can be upgraded to 12 LFF chassis with 8 to 12 upgrade option installed.

Installing the 8-bay SFF drive cage

This option can be installed in boxes 1 and 2.
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
Hardware options installation
55