Homelink® Wireless Control System (If So Equipped) - Mitsubishi MOTORS Outlander 2019 Owner's Manual

®
HomeLink Wireless Con-
trol System
(if so equipped)
®
HomeLink Wireless Control System is a
registered trademark of Gentex Corporation.
®
HomeLink provides a convenient way to
replace up to 3 hand-held radio-frequency
(RF) transmitters used to activate devices
such as gate operators, garage door openers,
entry door locks, security systems, even home
®
lighting. Additional HomeLink
can be found at www.homelink.com,
www.youtube.com/HomeLinkGentex, or by
®
calling the toll-free HomeLink
800-355-3515.
WARNING
®
 Do not use HomeLink with any garage
door opener that lacks safety stop and
reverse features as required by U.S. Fed-
eral Regulations. A garage door opener
which cannot detect an object in the path
of a closing garage door and then auto-
matically stop and reverse, does not meet
current U.S. Federal Regulations. Using a
garage door opener without these features
increases the risk of serious injury or
death.
WARNING
 During programming, your garage door
or gate may open or close. Make sure that
N00554301040
people and objects are clear of the garage
door or gate that you are programming.
NOTE
 Once HomeLink
original transmitter for future programming
procedures (for example, new vehicle pur-
chases). Upon sale of the vehicle, the pro-
information grammed HomeLink
erased for security purposes. Refer to
"Cleaning the programmed information" on
page 5-237.
-Hotline at 1-
 You can program a maximum of 3 devices.
To change or replace any of the 3 devices
after it has been initially programmed, you
must first erase the current settings.
See "Cleaning the programmed information"
on page 5-237 or "Reprogramming a single
®
HomeLink
HomeLink® Wireless Control System (if so equipped)
®
is programmed, retain the
®
buttons should be
button" on page 5-237.
1- HomeLink ®
button 1
2- HomeLink ®
button 2
3- HomeLink ®
button 3
Before programming Home-
®
Link
 Some garage door openers manufactured
after 1995 have "rolling code protection".
To program a garage door opener
equipped with "rolling code protection";
you will need to access the garage door
opener motor to press the motor's "Learn"
or "Smart" buttons. For convenience, use
a ladder and another person to assist you.
 It is recommended that a new battery be
placed in the hand-held transmitter of the
device being programmed to HomeLink
for quicker training and accurate trans-
mission of the radio-frequency signal.
Features and controls
5
N00584600029
®
5-233