Mitsubishi MOTORS Outlander 2019 Owner's Manual page 299

 Windshield is dirty
If the automatic high beam system determines
that its performance has been degraded, the
warning display will appear.
This can occur when
 Foreign objects, such as dirt, snow or ice,
adhere to the windshield of the sensor
portion.
 In adverse weather conditions, such as
rain, snow, sand storms, etc.
 A front vehicle or an oncoming vehicle is
splashing water, snow or dirt.
When the sensor performance returns, the
automatic high beam system will resume
operation.
If the warning display does not disappear
after waiting for a while, there is a possibility
that the sensor has a malfunction. Contact an
authorized Mitsubishi Motors dealer for
inspection of the sensor.
Welcome light
This function turns on the front side-marker
and parking lights for approximately 30 sec-
onds after the UNLOCK button on the remote
control transmitter is pressed when the com-
bination headlights and dimmer switch is in
the "OFF" or "AUTO" position (vehicles
equipped with the automatic light control).
The welcome light function will operate only
when it is dark outside the vehicle.
NOTE
 While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK button on the remote con-
trol transmitter.
• Turn the combination headlights and dim-
mer switch to the " " or "
• Turn the ignition switch to the "ON" posi-
tion or put the operation mode in ON.
 It is possible to modify functions as follows:
• The headlights can be set to come on in the
low beam setting.
• The welcome light function can be deacti-
vated.
Combination headlights and dimmer switch
NOTE
For details, consult a Mitsubishi Motors
N00563201250
dealer.
On vehicles equipped with the Smartphone
Link Display Audio, screen operations can
be used to make the adjustment.
Refer to the separate owner's manual for
details.
Coming home light
This function turns on the headlights in the
low beam setting for approximately 30 sec-
onds after the ignition switch is turned to the
"OFF" or "LOCK" position or the operation
mode is put in OFF.
1. Turn the combination headlights and dim-
mer switch to the "OFF" or "AUTO"
position (vehicles equipped with the auto-
" position.
matic light control).
2. Turn the ignition switch to the "OFF" or
"LOCK" position or put the operation
mode in OFF. Also, if a key was used to
start the engine, remove the key from the
ignition switch.
Features and controls
5
N00547301181
5-217