Mitsubishi MOTORS Outlander 2019 Owner's Manual page 93

NOTE
 To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to "Electronic immobilizer (Anti-
theft starting system): Customer key pro-
gramming" on page 5-6.
General information
Your keyless entry system operates on a radio
frequency subject to Federal Communica-
tions Commission (FCC) Rules (For vehicles
sold in U.S.A.) and Industry Canada Rules
(For vehicles sold in Canada). This device
complies with Part 15 of FCC Rules and
Industry Canada licence-exempt RSS stan-
dard(s).
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation.
CAUTION
 Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user's authority to oper-
ate the equipment.
Procedure for replacing the
remote control transmitter bat-
tery
N00546101124
1. Before replacing the battery, remove static
electricity from your body by touching a
metal grounded object.
2. Remove the screw (A) from the remote
control transmitter.
Keyless entry system (if so equipped)
3. With the Mitsubishi mark facing you,
insert the cloth-cov-ered tip of a flat blade
screwdriver into the notch in the remote
control transmitter case and use it to open
the case.
N00544101205
NOTE
 Be sure to perform the procedure with the
Mitsubishi mark facing you. If the Mitsubi-
shi mark is not facing you when you open the
remote control transmitter case, the buttons
may come out.
Features and controls
5
5-11