Mitsubishi MOTORS Outlander 2019 Owner's Manual page 420

Replacement of light bulbs
Headlights (high beam, halo-
gen bulb type)
1. When replacing the bulb on the right side
of the vehicle, remove the clip (A) hold-
ing down the washer tank spout and move
the spout toward the rear of the vehicle.
9
2. Turn the cap (B) counterclockwise to
remove it.
*- Front of the vehicle
9-36 Vehicle care and maintenance
3. Turn the bulb (C) counterclockwise to
remove it and then while holding down
the tab (D), pull out the bulb (E).
N00901901158
4. To install the bulb, perform the removal
steps in reverse.
Headlights (high beam, LED
type)
NOTE
 The headlights use an LED instead of a halo-
gen bulb.
Check with an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when the light needs to be repaired or
replaced.
Headlight aim adjustment
The alignment of the headlights should be
checked by an authorized Mitsubishi Motors
dealer or a repair facility of your choice.
Front side-marker lights
1. When replacing the bulb on the left side
of the vehicle, move the relay box toward
the rear of the vehicle. (if so equipped)
(Refer to "Headlight (low beam, halogen
bulb type): Step 1" on page 9-35.
N00901901161
N00943201359
N00915501214