Mitsubishi MOTORS Outlander 2019 Owner's Manual page 210

Blind Spot Warning (BSW) (with Lane Change Assist) (if so equipped)
To operate
When the BSW switch is pressed while the
operation mode is ON, the BSW indicator
light in the instrument cluster comes on and
the BSW becomes in stand by state. When the
BSW switch is pressed again, the BSW indi-
5
cator light in the instrument cluster goes off
and the BSW turns off.
Indicator light
If you turn the BSW ON/OFF, the Rear Cross
Traffic Alert (RCTA) also turns ON/OFF at
the same time.
5-128 Features and controls
NOTE
 When the operation mode is set to OFF, the
N00593500079
selected condition just before setting to OFF
is retained.
 The BSW operates when all of the following
conditions are met.
• The operation mode is put in ON.
• The selector lever is in positions other than
"P" (PARK) and "R" (REVERSE).
• The speed of your vehicle is approximately
6 mph (10km/h) or higher.
When the sensor detects an
approaching vehicle
When the BSW indicator light in the instru-
ment cluster is on, if a vehicle is approaching
your vehicle in the detection area, the Blind
Spot Warning light in the outside rearview
mirror illuminates.
If the turn signal lever is operated to the side
where the Blind Spot Warning light is illumi-
nated, the Blind Spot Warning light will blink
and the system will beep three times to alert
the driver.
NOTE
 The Blind Spot Warning light in the outside
rearview mirror may come on or blink in the
following conditions.
• When driving very near the guardrail or the
concrete wall.