Mitsubishi MOTORS Outlander 2019 Owner's Manual page 318

HomeLink® Wireless Control System (if so equipped)
5
1. Within 5 seconds after successfully pro-
gramming the garage door opener (refer
to "Programming a new HomeLink
section), both garage door operation indi-
cators (A) will flash rapidly green indicat-
ing that the garage door feedback has
been enabled.
If the indicators do not flash, perform
steps 2 and 3 while pressing the Home-
®
Link button up to the first 10 times after
successful programming.
2. Press and release the programmed Home-
®
Link button to activate the door. You
now have 1 minute in which to complete
step 3.
5-236 Features and controls
3. Once the door has stopped, press and
release the "Learn" or "Smart" button on
the garage door opener (refer to your
garage door opener owner's manual for
the location of the "Learn" button). Both
®
the HomeLink garage door operation
indicators will flash rapidly green upon
successful synchronization with the door
opener (within 5 seconds).
Operating HomeLink
To operate, simply press and release the pro-
®
"
®
grammed HomeLink button. Activation will
now occur for the trained device (i.e. garage
door opener, gate operator, security system,
entry door lock, home/office lighting, etc.).
For convenience, the hand-held transmitter of
the device may also be used at any time.
Garage door feedback
®
The HomeLink has the capability of receiv-
ing garage door status from compatible
garage door opener systems. Refer to "Addi-
tional steps for programming a door system
with feedback" on page 5-235.
Garage door status is then displayed with
indicators (A).
®
The indicators will illuminate/blink in
N00585000020
response to the following conditions:
: Blinking
Garage door opener closing
Garage door opener closed
Out of range
N00585200022
Garage door opener opening
Garage door opener opened
Out of range
: Illuminates
(orange)
(green)
(red)
(orange)
(green)
(red)