Headlight Leveling Switch (If So Equipped) - Mitsubishi MOTORS Outlander 2019 Owner's Manual

Headlight leveling switch (if so equipped)

3. Within 60 seconds of turning the ignition
switch to the "OFF" or "LOCK" position
or putting the operation mode in OFF, pull
the turn signal lever toward you.
5
4. The headlights will come on in the low
beam setting for approximately 30 sec-
onds. After the headlights go off, the
headlights can be turned on again in the
low beam setting for approximately 30
seconds by pulling the turn signal lever
toward you within 60 seconds of turning
the ignition switch to the "OFF" or
"LOCK" position or putting the operation
mode in OFF. To turn on the headlights
again after 60 seconds of turning the igni-
tion switch to the "OFF" or "LOCK"
position or putting the operation mode in
OFF, repeat the process from step 1.
5-218 Features and controls
NOTE
 While the coming home light function is
operating, perform one of the following
operations to cancel the function.
• Pull the turn signal lever toward you.
• Turn the combination headlights and dim-
mer switch to the " " or "
or put the operation mode in ON.
• Turn the ignition switch to the "ON" posi-
tion or put the operation mode in ON.
 It is possible to modify functions as follows:
• The time that the headlights remain on can
be changed.
• The coming home light function can be
deactivated.
For details, consult a Mitsubishi Motors
dealer.
On vehicles equipped with the Smartphone
Link Display Audio, screen operations can
be used to make the adjustment.
Refer to separate owner's manual for details.
Headlight leveling switch
so equipped)
The direction of the headlight beam (the
direction in which the light shines) alters
according to the number of people and the
load in the vehicle. Lower the headlight angle
if it is too high due to the number of people
and/or the load in the vehicle so that the head-
lights' glare does not distract the drivers of
approaching vehicles. First set the light
switch to the "
headlight leveling switch knob to lower the
beam. The greater the number on the head-
light leveling switch knob, the lower the
" position
beam will point.
Set the switch to the appropriate position so
that the headlight beam is level with the road.
WARNING
(if
 To avoid distraction while driving, always
perform headlight adjustments before
vehicle operation.
N00537101115
NOTE
 Start adjusting when the knob is at the "0"
position (when the beam is at its highest).
" position, then turn the