Mitsubishi MOTORS Outlander 2019 Owner's Manual page 143

4- Left
NOTE
 After adjusting, return the lever to the
"•"(OFF) position.
To retract the mirror
The outside mirror can be retracted towards
the side window to prevent damage when
parking in tight locations.
Except for vehicles equipped with the
mirror retractor switch
Push the mirror towards the back of the vehi-
cle with your hand to retract it in. When
extending the mirror, pull it out towards the
front of the vehicle until it clicks to lock in
place.
For vehicles equipped with the mirror
retractor switch
Retracting and extending the mir-
rors using the mirror retractor
switch
With the ignition switch in the "ON" or
N00549201197
"ACC" position or the operation mode in ON
or ACC, push the mirror retractor switch to
retract the mirrors. Push it again to extend the
mirrors to their original positions.
After placing the ignition switch in the
"LOCK" position or the operation mode in
OFF, it is possible to retract and extend the
mirrors using the mirror retractor switch for
approximately 30 seconds.
Outside rearview mirrors
CAUTION
 It is possible to retract and extend the mirrors
by hand. After retracting a mirror using the
mirror retractor switch, however, you should
extend it by using the switch again, not by
hand. If you extended the mirror by hand
after retracting it using the switch, it would
not properly lock in position. As a result, it
could move because of the wind or vibration
while you are driving, taking away your rear-
ward visibility.
NOTE
 Be careful not to get your hands trapped
while a mirror is moving.
 If you move a mirror by hand or it moves
after hitting a person or object, you may not
be able to return it to its original position
using the mirror retractor switch. If this hap-
pens, push the mirror retractor switch to
place the mirror in its retracted position and
then push the switch again to return the mir-
ror to its original position.
 When freezing has occurred and mirrors fail
to operate as intended, please refrain from
repeated pushing of the retractor switch as
this action can result in burn-out of the mir-
ror motor circuits.
Features and controls
5
5-61