Mitsubishi MOTORS Outlander 2019 Owner's Manual page 263

NOTE
 When "---" is displayed, after a certain dis-
tance and a certain period of time, the dis-
play is reset and the time until the next
periodic inspection is displayed.
 If you accidentally reset the display, consult
an authorized Mitsubishi Motors dealer for
assistance.
Changing the function settings
The "Average fuel consumption reset mode",
"Fuel consumption unit" and "Temperature
unit" setting can be modified as desired,
when the ignition switch is in the "ON" posi-
tion.
CAUTION
 The driver should not operate the display
while the vehicle is in motion.
 When operating the system, stop the vehicle
in a safe area.
Changing the reset mode for aver-
age fuel consumption
You can change the mode condition for the
average fuel consumption display to "Auto
reset" or "Manual reset".
1. When you lightly press the multi informa-
tion display switch a few times, the infor-
mation display switches to the driving
range display.
Refer to "Information display" on page
5-176.
2. Each time you press the multi information
display switch for 2 seconds or more on
driving range display, you can switch
reset mode for average fuel consumption.
(A: Auto reset mode, B: Manual reset
N00556801209
mode)
 Manual reset mode
 When the average fuel consumption is
being displayed, if you hold down the
N00575501029
multi information display switch, these
calculations will be reset to zero.
Multi Information display - Type 2
 When the ignition switch is turned to the
"ON" position from the "ACC" or "OFF"
position, the mode setting changes auto-
matically from manual to auto.
 Auto reset mode
 When the average fuel consumption is
being displayed, if you hold down the
multi information display switch, these
calculations will be reset to zero.
 When the ignition switch has been set to
the "ACC" or "OFF" position for about 4
hours or more, the average fuel consump-
tion display will automatically reset.
NOTE
 The average fuel consumption display can be
reset separately for the auto reset mode and
for the manual reset mode.
 Disconnecting the battery cable will erase
from memory the manual reset mode or auto
reset mode setting for the average fuel con-
sumption display.
 The initial (default) setting is "Auto reset
mode".
Features and controls
5
5-181