Mitsubishi MOTORS Outlander 2019 Owner's Manual page 194

Adaptive Cruise Control System (ACC) (if so equipped)
WARNING
• When driving on a winding road.
5
 Never use the ACC in the following situa-
tions:
• In heavy traffic.
• On winding roads.
• On slippery roads, such as icy, snow-cov-
ered or dirt roads.
• In adverse weather conditions, such as
rain, snow or sand storms, etc.
• On steep downslopes.
• When the inclination of a road fre-
quently changes.
• When the approach alarm frequently
sounds.
• When your vehicle is towed or is towing
another vehicle.
• When your vehicle is on a chassis dyna-
mometer or free rollers.
• When tire inflation pressures are not
adequate.
• When the temporary spare tire is being
used.
• When the radar sensor and/or its sur-
rounding area are damaged or deformed.
5-112 Features and controls
CAUTION
 To maintain proper performance of the ACC:
• Always clean the surface of the radar sen-
sor.
• Avoid impacting the radar sensor or its sur-
rounding area.
• Do not put a sticker on the radar sensor or
its surrounding area.
• Do not paint the radar sensor.
• Do not install a grill guard.
• Do not modify the radar sensor or its sur-
rounding area.
• Always use tires of the same size, same
type, and same brand, and which have no
significant wear differences.
• Do not modify the vehicle's suspension.
To increase the set speed
There are two ways to increase the set speed.
By using the "RES +" switch:
The set speed will increase by 1 mph (1
km/h) every time you push up the "RES +"
switch while the ACC is activated. If you
hold the switch pushed up, the set speed
increases in 5 mph (5 km/h) increments.
NOTE
 There is some time lag until the vehicle
begins accelerating to the new set speed after
the set speed has been changed.
 The set speed can be changed even while
your vehicle is following a vehicle in front
using the ACC. In this case, however,
although the set speed itself is increased,
your vehicle will not accelerate.
N00581500027
 When the switch is held, a buzzer will sound
every time the set speed changes
By using the accelerator pedal:
When the accelerator pedal is depressed
while driving with the ACC control working,
you can accelerate the vehicle beyond the
presently set speed.
When the vehicle speed reaches your desired
speed, push down and release the "SET -"