Mitsubishi MOTORS Outlander 2019 Owner's Manual page 157

Selector lever operation
As an additional safety precaution, models
equipped with a continuously variable trans-
mission have a shift-lock device that holds
the selector lever in the "P" (PARK) position.
To move the selector lever from the "P"
(PARK) position to another position, follow
the steps below.
1. Press and hold the brake pedal down.
2. Move the selector lever to the desired
position.
NOTE
 The selector lever cannot be moved from "P"
(PARK) to other position if the ignition
switch is set to the "OFF" or "LOCK" or
"ACC" position, or if the key has been
removed, or the operation mode is put in
OFF or ACC, or if the brake pedal is not
pressed and held down.
The CVT selects an optimum ratio automati-
cally when the selector lever is in the "D"
(DRIVE) position, depending on the speed of
the vehicle and the position of the accelerator
pedal.
N00560301090
Except for vehicles equipped with sportronic
steering wheel paddle shifter
For vehicles equipped with sportronic steering
wheel paddle shifter
Set the selector lever in the gate to
operate while the brake pedal is
depressed.
Continuously variable transmission (CVT) (if so equipped)
Set the selector lever in the gate to
operate.
WARNING
 Always press the brake pedal when shift-
ing the selector lever into a selector posi-
tion from the "N" (NEUTRAL) position.
When beginning to drive, do not shift the
selector lever from the "N" (NEUTRAL)
position while pressing the accelerator
pedal. This will cause the vehicle to
"jump" forward or backward.
NOTE
 To prevent mistakes in operating the lever,
make sure you stop briefly at each position.
After operating, check the position in the
multi-information display.
 If the brake pedal is not depressed and held,
the shift-lock device activates to prevent the
selector lever from being moved from the
"P" (PARK) position.
 For a shift indicated by
tion, depress the brake pedal before moving
the selector lever. If you attempt to move the
selector lever before depressing the brake
pedal, the selector lever may be immovable.
in the illustra-
Features and controls 5-75
5