Mitsubishi MOTORS Outlander 2019 Owner's Manual page 195

switch and release the accelerator pedal; the
new speed is then set in the system.
WARNING
 The ACC braking control and approach
alarm functions will not work while the
accelerator pedal is depressed.
NOTE
 The set speed indicator in the multi informa-
tion display will show "---" while the accel-
erator pedal is depressed.
 If the "SET -" button is not pushed down
while depressing the accelerator pedal, your
vehicle speed will return to the set speed,
after the accelerator pedal is released. When
the accelerator pedal is released, the ACC
braking control and approach alarm func-
tions may not immediately work.
To decrease the set speed
There are two ways to decrease the set speed.
By using the "SET -" switch:
The set speed will decrease by 1 mph (1
km/h) every time you push down the "SET -"
switch while the ACC is activated. If you
hold the switch pushed down, the set speed
decreases in 5 mph (5 km/h) increments.
NOTE
 There is some time lag until the vehicle
begins decelerating after the set speed has
been changed.
Adaptive Cruise Control System (ACC) (if so equipped)
NOTE
 The set speed can be changed even while
N00581600028
your vehicle is following a vehicle in front
using the ACC. In this case, however,
although the set speed itself is decreased,
your vehicle will not decelerate.
 When the switch is held, a buzzer will sound
every time the set speed changes
By using the brake pedal:
By depressing the brake pedal while the ACC
is activated, the ACC control is canceled and
your vehicle speed will decrease.
At the point where the vehicle speed reaches
your desired speed, push down and release
the "SET -" switch; the new speed is then set
in the system.
Features and controls
5
5-113