Power window control
Testing the theft-alarm system
Use the following procedure to test the sys-
tem:
1. Lower the driver's window.
2. Arm the system as explained in "Armed
5
stage".
3. Make sure that the theft-alarm indicator
comes on and flashes for approximately
20 seconds.
4. Wait a few seconds and then unlock the
driver's side door by using the inside door
lock knob. Open the door.
5. Make sure that the horn sounds intermit-
tently and the headlights blink when a
door is opened.
6. Disarm the system by unlocking all doors
and the liftgate by using the keyless entry
system or the F.A.S.T.-key operation.
5-48
Features and controls
Power window control
N00510601157
1- Open (down)
2- Close (up)
NOTE
Never try to operate the main switch and
sub-switch in different directions at the same
time. This will freeze the window in posi-
tion.
Operating the power windows repeatedly
with the engine stopped will run down the
battery. Use the window switches only while
the engine is running.
WARNING
Before operating the power windows,
make sure that nothing can be trapped
(head, hands, fingers, etc.) in the window.
WARNING
Never leave the vehicle without carrying
N00510800383
the key.
Never leave children or unreliable adults
unattended inside the vehicle.
Main switch
The main switch located on the driver's door
can be used to operate all the windows.
A window can be opened or closed by operat-
ing the corresponding switch.
Press the switch down to open the window,
and pull up the switch to close it.
If the switch is fully pressed down/pulled up,
the door window automatically opens/closes
completely.
If you want to stop the window movement,
operate the switch lightly in the reverse direc-
tion.
N00548701166