Front fog lights (LED type)
NOTE
The fog lights use an LED instead of a halo-
gen bulb.
Check with an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when the light needs to be repaired or
replaced.
Rear combination lights
1. Open the liftgate.
2. Remove the screws (A), and then move
the light unit toward the rear of the vehi-
cle to unfix the notch (B) and pins (C).
3. Turn the socket counterclockwise and
remove it, and then pull the bulb out of
N00943601988
the socket.
N00943701598
D- Rear turn signal light
E- Tail light and stop light (LED) - cannot
be replaced
NOTE
The rear side-marker light, tail light and stop
light use an LED instead of the bulb.
Check with an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when the light needs to be repaired or
replaced.
4. To install the bulb, perform the removal
steps in reverse.
Replacement of light bulbs
NOTE
When mounting the light unit, align the
notch (F) and pin (G) on the light unit with
the clip (H) and hole (I) in the body.
Back-up lights
1. Push the light unit upward to remove it.
NOTE
Wrap a cloth around the tip of the screw-
driver to keep from scratching the lens.
Vehicle care and maintenance
9
N00929101080
9-39