10. Install the bottle onto the compressor.
NOTE
When installing the bottle, align the projec-
tion (I) on the bottle with the indentation (J)
in the compressor.
11. Securely attach the bottle hose (F) to the
tire valve (E).
CAUTION
If the bottle hose is not attached securely, the
tire sealant will leak out from the tire valve
and the tire may not inflate to the specified
pressure.
12. Pull out the compressor's power cord (K),
insert the plug on the cord into the 12 V
power outlet (L), and then turn the igni-
tion switch or the operation mode to the
ACC position. (Refer to "12 V power out-
let" on page 5-232.)
Turn ON the compressor switch (M) and
inject all of the tire sealant and inflate the
tire to the specified pressure. (Refer to
"Tire inflation pressures" on page 9-20.)
If there is a gap between the tire and
wheel, push the tread area toward the cen-
ter of the wheel to close the gap before
running the compressor.
Tire repair kit (if so equipped)
WARNING
Do not place your hand or fingers between
the tire and wheel while inflating the tire.
Your hand or fingers may become caught
between the tire and wheel.
CAUTION
The supplied compressor is designed only
for inflation of your vehicle tires.
The compressor is designed to run on a vehi-
cle's 12 V power supply. Do not connect it to
any other power source.
The compressor is not waterproof. If you use
it in rain, make sure water does not get on it.
For emergencies
8
8-9