Mitsubishi MOTORS Outlander 2019 Owner's Manual page 137

NOTE
 If the Electric parking brake must be applied
in an emergency situation, pull and hold the
Electric parking brake switch to apply the
Electric parking brake. At that time, the fol-
lowing warning display will appear in the
multi-information display and a buzzer will
sound, however you should continue to pull
and hold the Electric parking brake switch.
 When parking on steep grades, pull up the
Electric parking brake switch twice (once
more after the operation is completed once).
The maximum effect of the parking brake
will be obtained.
 If the parking brake does not hold the vehicle
stationary after the foot brake is released,
contact an authorized Mitsubishi Motors
dealer or a repair facility of your choice.
 When the ignition switch or the operation
mode is other than ON, if the Electric park-
ing brake is applied, the Electric parking
brake indicator light comes on for a while.
NOTE
 If the Electric parking brake switch is repeat-
edly operated in a short time, the following
warning display will appear in the multi-
information display and the Electric parking
brake will temporarily stop working. In such
case, wait for approximately 1 minute until
the warning display disappears, and operate
the Electric parking brake switch again.
 The brake warning light (red) and the indica-
tor light on the Electric parking brake switch
may blink. This does not indicate a malfunc-
tion, the lights go off when/if the Electric
parking brake is released.
 Depending on the situation, the Electric
parking brake may be applied automatically.
Refer to "Brake auto hold" on page 5-92.
Parking brake
To release
Manual operation
1. Make sure that the ignition switch is in
the "ON" position or the operation mode
is ON.
2. Press down the Electric parking brake
switch while depressing the brake pedal.
Automatic operation
When the accelerator pedal is depressed
slowly while all of the following conditions
are met, the Electric parking brake is auto-
matically released.
 The engine is running.
 The selector lever is in the "D" (DRIVE)
or the "R" (REVERSE) position.
 The driver's seat belt is fastened.
Features and controls
5
5-55